use the arp command, to set a static arp address to an ip
ie

arp -s 192.168.10.100 aa-aa-bb-cc-c6-09
or what ever the arp command is on your OS

then try and telnet to the access point with 192.168.10.100
if that fails, then there may be some special software needed to configure
it

Once you assign it an ip ( the access point itself ) remove the static entry
for the arp address you added

Cheers, Glen
----- Original Message -----
From: "Robert Guthrie" <robmailguthrie.net.dhis.org>
To: <wirelesslists.samba.org>
Sent: Saturday, July 14, 2001 2:23 PM
Subject: WavePoint Accesspoint Info

> hi, i have a couple 2mbit (i think) Lucent Wavepoint Accesspoints.
>
> i have their mac addresses, as they are written on the bottom of them..
but
> i dont know how to configure them. i dont have their ip address, or
> anysoftware. there are jumpers and a reset (?) switch on them also..
>
> can someone tell me how to configure these, or give me a site with some
> decent info on these?
>
>
>

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]