OSEC

Neohapsis is currently accepting applications for employment. For more information, please visit our website www.neohapsis.com or email hr@neohapsis.com
 
From: Thomas Mattisson (thomas.mattissonmobilearts.se)
Date: Sat Jan 05 2002 - 09:34:56 CST

  • Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

    Hi,

    I've been trying to get my dlink card working under Linux using
    orinoco_cs but it is a bit problematic. When using 2.4.17 and
    pcmcia-cs 3.1.31 everything works fine for an hour or two and
    then I get alot of the following:

    Jan 4 23:11:53 maclay kernel: NETDEV WATCHDOG: eth0: transmit timed out
    Jan 4 23:11:53 maclay kernel: eth0: Tx timeout! Resetting card.
    Jan 4 23:11:53 maclay kernel: hermes 0x300: Timeout waiting for card
    to reset (reg=0x0000)!
    Jan 4 23:11:53 maclay kernel: eth0: Error -110 resetting card on Tx
    timeout!
    Jan 4 23:11:57 maclay kernel: NETDEV WATCHDOG: eth0: transmit timed out
    Jan 4 23:11:57 maclay kernel: eth0: Tx timeout! Resetting card.
    Jan 4 23:11:57 maclay kernel: eth0: Error -16 resetting card on Tx timeout!

    If I remove the card and plug it back in, it works again.

    I also tried to use version 0.09a of orinoco_cs with the above
    but then it fails to initialize with the following messages:

    Jan 5 16:18:17 maclay cardmgr[3257]: socket 1: D-Link DWL-650
    Jan 5 16:18:17 maclay cardmgr[3257]: executing: 'modprobe hermes'
    Jan 5 16:18:17 maclay cardmgr[3257]: executing: 'modprobe orinoco'
    Jan 5 16:18:17 maclay cardmgr[3257]: executing: 'modprobe orinoco_cs '
    Jan 5 16:18:17 maclay kernel: orinoco_cs: Card Services release does
    not match!
    Jan 5 16:18:17 maclay cardmgr[3257]: +
    /lib/modules/2.4.17/pcmcia/orinoco_cs.o: init_module: Operation
    not permitted

    I have disabled the CONFIG_MODVERSIONS when compiling the kernel.

    Anyone have any good suggestions?

    /Thomas