Dear Muscle community,

I'm a beginner in smart card technology
and now a little bit about smartcard
programming.

I haven't problems with CT-API and
the PC/SC interface, but how can i program an
I2C-bus card like towitoko m8p cards ?
Which APDU'S should I use for programming.
How can I use PC/SC for memory card programming ?
The tester application in the towitoko
shows examples for card reading and writing,
but how can I verify a Pin or change a Pin
for example. Are there any programming
examples avaiable ?
Another problem is, that the card reader
do not take any other card after a memory
card initialization. I always must plug out
my serial device to read a new Memory Card.

Thanks

Andi

PS: Are there any Linux interfaces like the
SCARD programming interface from towitoko
for Linux ?

-----------------------------------------------------------------------
LISCON GmbH http://www.liscon.com/
Kersche Andreas andiliscon.com

Richard-Wagner-Strasse 7 Tel: +43 699/11093881
A-9500 Villach Fax: +43 4242 214 855 99
AUSTRIA / EUROPE

***************************************************************
Unix Smart Card Developers - M.U.S.C.L.E.
(Movement for the Use of Smart Cards in a Linux Environment)
http://www.linuxnet.com/
To unsubscribe send an email to majordomolinuxnet.com with
unsubscribe sclinux
***************************************************************

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]