OSEC

Neohapsis is currently accepting applications for employment. For more information, please visit our website www.neohapsis.com or email hr@neohapsis.com
 
From: Matthew Raymer (mraymeruniversal-solutions.net)
Date: Tue Jun 25 2002 - 11:55:29 CDT

  • Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

    Hello,

    I recently purchased an ACS Smartcard Kit. I knew that I might have
    some difficulty because I am choosing Linux as my platform of
    development, but I am already writing under linux for other packages and
    would like the smartcard to be usable in my other work.

    My initial difficulty has been the driver itself. The one packaged in
    the kit is for the ACS Cybermouse ... which I assume works with the
    ACR30 serial smartcard reader, but I do not see any indication of
    compatibility in the kit. Also, the version number seems VERY low
    (0.3.5). A trip to the MUSCLE site for a newer driver took me straight
    back to acs.com.hk where I see only the 0.3.5 driver that got with my kit.

    Next, I noticed that pcsc-lite was version 0.7.8 on the kit's disk but
    that MUSCLE declares that there is a stable release of version 1.1.1.

    So, in my ingorance, I am trying to use the 0.3.5 driver with the 1.1.1
    pcsc-lite.

    When compile the driver code and install it, then compile the pcsc-lite
    code and install it as well (Ran installifd to set the reader.conf.), I
    then run the daemon. Nothing really seems to happen -- it doesn't core
    dump. When I ps -A, I see three processes running. So, I decide to run
    the ./testpcsc ... which tells me there is an error.

    After investigating the situation further, I determined that a message
    is being sent to the reader, but it is not receiving any response.

    After all my rambling here, I am convinced that I really do not know
    what I am doing and need a little friendly advise.

    1) Is that the correct driver for the ACS30 serial?
    2) Is there an alternate method to detect the smartcard reader?
    3) On another note, the development kit says that the devices are
    readers and writers but the device itself says nothing about being a
    writer. So, does it write cards too? Seems pretty useless as a
    development kit if it does not both read and write.
    4) If the driver mentioned above does work with the device, then is
    there a more recent version?

    Answers, insights, and cross-examintions are very welcome.

    Matthew A. Raymer

    ***************************************************************
    Unix Smart Card Developers - M.U.S.C.L.E.
    (Movement for the Use of Smart Cards in a Linux Environment)
    http://www.linuxnet.com/
    To unsubscribe send an email to majordomolinuxnet.com with
    unsubscribe sclinux
    ***************************************************************