From: Drasko DRASKOVIC (drasko.draskovicgmail.com)
Date: Wed Jun 30 2010 - 04:15:04 CDT

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Hi all,
I have seen strange issue Work etu setting-up for my controller.

Actually, after ATR reception, the card returns me this :
TA(1) = 0x94 Fi=512, Di=8, 64 cycles/ETU (62500 bits/s at 4.00
MHz, 78125 bits/s for fMax=5 MHz)

That would say, if I understood well, that before starting any
conversation to the card, I have to assure that my set up is (in my
set-up registers) Fi=512, Di=8.

However, I f I change contents of my registers, and set-up to new baud
speed, my commands are not recognized and I can see on SIM analyzer
that there are trash characters exiting my terminal.

I f I do not change speed (leave Fi = 372 adn Di = 1, as it was set up
for ATR) everything works fine.

What can be wrong ?

BR,
Drasko
_______________________________________________
Muscle mailing list
Musclelists.musclecard.com
http://lists.drizzle.com/mailman/listinfo/muscle

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]