Neohapsis is currently accepting applications for employment. For more information, please visit our website www.neohapsis.com or email email@example.com
Re: [ISSForum] Taps supporting traffic aggregation
From: Ken Kempster (KenKempster.net)
Date: Tue Jan 27 2004 - 10:24:51 CST
-----BEGIN PGP SIGNED MESSAGE-----
IMO the big problem with any device that sits in line of the traffic
is there is always the concern of it being a single point of failure.
Selling to your networking
team that the device will not become a bottle neck or failure point is
difficult at best.
Also, if you're looking to do RS kills, you will need another
physical path to send them
when using taps. When you're comparing the pros and cons of
deploying them, you need to factor in
the criticality of the network you will be tapping into.
If cost is a concern, then taps are probably a good approach but I
would confirm that
the physical infrastructure is designed so that a physical failure of
the tap does not affect
traffic flow; multi-path.
It has been my experience that the best approach is to design your
so that if there were a total failure of your monitoring environment,
it will not impact production networking/traffic flow.
This is typically the more expensive approach but the safest one.
Thierry Bôle wrote:
| Hi Ken,
| I guess you speak about the IDS Balancer because Toplayer don't
| have taps supporting traffic aggregation ( maybe they will ...) but
| I'm not interested in load-balancing traffic between multiple
| The goal with taps supporting traffic aggregation is to simplify
| IDS architecture and to save cost:
| With normal taps, you need to use Network Sensor with integrated
| full-duplex segment monitoring or to use layer 7 switches (IDS
| balancer for example) to aggregage traffic for your Network Sensor.
| Now, you can connect your Network Sensor directly to the port
| aggregator tap.
| I would be interested to have your feedback on using such devices
| and especially if they really deconflict collisions as it can be
| described in the datasheets (taps are normally passive devices)
| Ken Kempster wrote:
| Have you looked at TopLayer? I've tested the product a few years
| ago and it looked good for aggregating ports/traffic, load balance
| between multiple sensors and still retain an aggregated port for
| your sniffer.
| Thierry Bôle wrote:
| | Hello, | | Has anyone tested taps supporting traffic aggregation
| with ISS | products (with the capability to mirror the traffic only
| on one | link) ? | | I'm aware of the bandwidth limitations we can
| have: if the 2 | network ports are operating at 100mbps and the IDS
| port is | operating at 100mbps as well, then under sustained
| aggregate | bandwidth of greater than 100mbps, packets will get
| dropped. | | I guess it should cause no problems with dropped
| packets if I'm | monitoring internet links with low utilisation. |
| | Any feedback appreciated. | | Thierry | |
| _______________________________________________ ISSForum mailing |
| list ISSForumiss.net | | TO UNSUBSCRIBE OR CHANGE YOUR
| SUBSCRIPTION, go to | https://atla-mm1.iss.net/mailman/listinfo
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.3 (MingW32)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org
-----END PGP SIGNATURE-----
ISSForum mailing list
TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to https://atla-mm1.iss.net/mailman/listinfo