My system seems to hang on every other boot. It doesn't matter if it was a warm
or cold boot. The only way to get the system to start properly is to power
the system off, and then back on. dmesg follows, with 5 lines breaking where
the hang happens. Any ideas what's going on here? Valid bug? This started
happening right after I got 2.8 installed (rebooted from the install, and it
hung, powered it off, and back on, and it started right up).

OpenBSD 2.8 (GENERIC) #399: Mon Nov 6 10:59:23 MST 2000
    deraadti386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Intel Pentium II (Celeron) ("GenuineIntel" 686-class, 256KB L2 cache)
397 MHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SYS,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR

real mem = 133722112 (130588K)
avail mem = 118976512 (116188K)
using 1657 buffers containing 6787072 bytes (6628K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(00) BIOS, date 03/25/01, BIOS32 rev. 0 0xffe90

apm0 at bios0: Power Management spec V1.2
apm0: battery life expectancy 100%
apm0: AC on, battery charge high, estimated 5:01 hours
pcibios0 at bios0: rev. 2.1 found at 0xf0000[0x10000]
pcibios0: PCI IRQ Routing Table rev. 1.0 found at 0xfbda0, size 112 bytes (5
entries)
pcibios0: PCI Interrupt Router at 000:07:0 ("Intel 82371 (Triton MX) PCI-ISA
and IDE" rev 0x00)
pcibios0: PCI bus #3 is the last bus
pci_addr_fixup: 000:03:0 0x104c 0xac1c new address 0x08000000
pci_addr_fixup: 000:03:1 0x104c 0xac1c new address 0x08001000
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "Intel 82443BX PCI-AGP" rev 0x03
ppb0 at pci0 dev 1 function 0 "Intel 82443BX AGP" rev 0x03
pci1 at ppb0 bus 1
"Neomagic Magicgraph NM2200" rev 0x12 at pci1 dev 0 function 0 not configured

neo0 at pci1 dev 0 function 1 "Neomagic MagicMedia 256AV" rev 0x12: irq 5

ac97: codec id 0x83847605 (SigmaTel STAC9704)
ac97: codec features 18 bit DAC, 18 bit ADC, Rockwell 3D
audio0 at neo0
cbb0 at pci0 dev 3 function 0 "Texas Instruments PCI1225 PCI-CardBus" rev 0x01

cbb1 at pci0 dev 3 function 1 "Texas Instruments PCI1225 PCI-CardBus" rev 0x01

pcib0 at pci0 dev 7 function 0 "Intel 82371AB PIIX4 ISA" rev 0x02
pciide0 at pci0 dev 7 function 1 "Intel 82371AB IDE (PIIX4)" rev 0x01: DMA,
channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <IBM-DARA-206000>
wd0: can use 32-bit, PIO mode 4, DMA mode 2, Ultra-DMA mode 2
wd0: 16-sector PIO, LBA, 5729MB, 12416 cyl, 15 head, 63 sec, 11733120 sectors

pciide0: channel 0 interrupting at irq 14
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 (using DMA data transfers)

atapiscsi0 at pciide0 channel 1
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <SAMSUNG, CD-ROM SCR-2438, d026> SCSI0 5/cdrom
removable
cd0: can use 32-bit, PIO mode 4, DMA mode 2
pciide0: channel 1 interrupting at irq 15
cd0(pciide0:1:0): using PIO mode 4, DMA mode 2 (using DMA data transfers)
"Intel 82371AB USB (PIIX4)" rev 0x01 at pci0 dev 7 function 2 not configured

"Intel 82371AB Power Management (PIIX4)" rev 0x02 at pci0 dev 7 function 3 not
configured
cbb0: irq 11
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 2 device 0 cacheline 0x8, lattimer 0x20
pcmcia0 at cardslot0
cbb1: irq 11
cardslot1 at cbb1 slot 1 flags 0
cardbus1 at cardslot1: bus 3 device 0 cacheline 0x8, lattimer 0x20
pcmcia1 at cardslot1
isa0 at pcib0
isadma0 at isa0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
vt0 at isa0 port 0x60/16 irq 1: vga 80 col, color, 8 scr, mf2-kbd
pms0 at vt0 irq 12
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask c840 netmask c840 ttymask d8c2
pctr: 686-class user-level performance counters enabled
mtrr: Pentium Pro MTRR support
dkcsum: wd0 matched BIOS disk 80
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302
xl0 at cardbus0 dev 0 function 0: 3Com 3c575B-TX Ethernet: irq 11 address 00:50:04:b6:23:93

amphy0 at xl0 phy 0: Am79C873 10/100 media interface, rev. 0
pccom3 at pcmcia1 function 0 "3Com, 3CXM/3CCM556, Megahertz 56K Cell/Telephony
Modem" port 0x23f8/8: ns16550a, 16 byte fifo

Web Mail services provided by http://www.aa.net

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]