OSEC

Neohapsis is currently accepting applications for employment. For more information, please visit our website www.neohapsis.com or email hr@neohapsis.com
 
From: Michael C. Ibarra (ibarrahawk.com)
Date: Thu May 02 2002 - 08:34:56 CDT

  • Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

    This is odd, we sell boxes with a motherboard that uses the
    same chip, in fact we've donated one to OpenBSD developers
    just to be sure, and we've never had a problem since 2.9. Are
    you sure that this mobo is good and/or turned on at the bios?

    -mike

    Michael C. Ibarra
    Hawk Technologies, Inc
    http://www.hawk.com
    800.hawk.com

    Quoting Ioan Nemes <inemestransylvania.com.au>:

    > Greetings,
    >
    > According to the `siop` man page, the the `siop` driver supports
    > the following LSI/Symbios Logic/NCR 53c8xx and related SCSI controller
    > chips:
    >
    > - 53c810, 53c810a and 53c815 (Fast SCSI)
    > - 53c820, 53c825 and 53c825a (Fast-Wide SCSI)
    > - 53c860 (Ultra SCSI)
    > - 53c875 and 53c875j (Ultra-Wide SCSI)
    > - 53c876 (Dual Ultra-Wide SCSI)
    > - 53c885 (Ultra-Wide SCSI and Ethernet)
    > - 53c895 and 53c895a (Ultra2-Wide SCSI)
    > - 53c896 (PCI 64bit, dual Ultra2-Wide SCSI)
    > - 53c1010 (PCI 64bit, dual Ultra3-Wide SCSI. NOTE: at this
    > time siop *supports* at most Ultra2-Wide with this chip)
    > - 53c1510D (dual Ultra2-Wide SCSI)
    >
    > siop replaces the older ncr driver which supported most of these devices.
    >
    > I am trying to install OpenBSD 3.0 on an Intel SAI2 server board (dual
    > Intel PIII 1.13 GHz CPUs, 512 MB registered RAM).
    >
    > The included LSI20160 (*single* channel) Ultra 160 SCSI HBA (*not*
    > surface mountad, but included, and sold together with the motherboard),
    > correctly identifies the attached SCSI devices (at the boot time, or if
    > I am starting the LSI SCSI utility - <Ctr+C>):
    >
    > IBM DDYS S93E hard disk (SCSI ID 0)
    > ARCHIVE Python 0416-XXX7550 tape drive (SCSI ID 5)
    > 53C1010-66 host adapter (SCSI ID 7)
    >
    > However, booting from the 3.0 CD-ROM, OpenBSD can't see the controller
    > and consequently the attached SCSI devices:
    >
    > .....
    >
    > vendor "Symbios Logic", unknown product 0x21 (class mass storage, subclass
    > SCSI, rev 0x01) at pci0 dev 6 function 0 not configured
    >
    > .....
    >
    > Did somebody successfully used this motherbord & SCSI conteroller with
    > OpenBSD 3.0?
    >
    > Ioan
    >

    --------------------------------------------------