From: Mario Ohnewald (mario.Ohnewaldgmx.de)
Date: Wed Aug 04 2004 - 03:39:07 CDT

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Hello Waldemar,

> > I would like to connect two networks trough two BSD boxes.
> > I have the following scenario:
> >
> > network 192.168.1.0 --->
> >
> > BOX1: rl0, 192.168.1.110; rl1 10.10.2.111 --->
> >
> > BOX2: rl0, 192.168.1.113; rl1 10.10.2.112 --->
> >
> > network 192.168.1.0
> >
> >
> > My ifconfig output:
> > -----------------------
> > # ifconfig -a
> > lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 33224
> > inet 127.0.0.1 netmask 0xff000000
> > inet6 ::1 prefixlen 128
> > inet6 fe80::1%lo0 prefixlen 64 scopeid 0x5
> > rl0: flags=8943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST> mtu 1500
> > address: 00:90:47:03:ac:df
> > media: Ethernet autoselect (none)
> > status: no carrier
>
> No carrier?

ermm...oops! This ifconfig must have been pasted after i have played around
a bit, but i was connected for sure!

>
> > inet 192.168.1.3 netmask 0xffffff00 broadcast 192.168.1.255
> > inet6 fe80::290:47ff:fe03:acdf%rl0 prefixlen 64 scopeid 0x1
> > rl1: flags=8943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST> mtu 1500
> > address: 00:30:84:74:ae:52
> > media: Ethernet autoselect (100baseTX full-duplex)
> > status: active
> > inet 192.168.1.4 netmask 0xffffff00 broadcast 192.168.1.255
> > inet6 fe80::230:84ff:fe74:ae52%rl1 prefixlen 64 scopeid 0x2
> > pflog0: flags=0<> mtu 33224
> > pfsync0: flags=0<> mtu 2020
> > enc0: flags=0<> mtu 1536
> > bridge0: flags=41<UP,RUNNING> mtu 1500
>
> Do you want to route packets or bridge them?

I would liek to bridge them.

> Do you think having rl0 and rl1 on the same logical subnet
> 192.168.1.0/255.255.255.0 will work correctly?
Yes, thats why i try to bridge here.

Thanks, Mario

--
NEU: WLAN-Router für 0,- EUR* - auch für DSL-Wechsler!
GMX DSL = supergünstig & kabellos http://www.gmx.net/de/go/dsl

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]